Activate Aux Heating with DIS/SSS/Progman OBD II

dudelange · Post by **dudelange** » Sat Oct 20, 2012 10:48 am

Hello guys! Nice to have joined this forum!

Here is my first request for help as a newbie:

I have OBD II which I have purchased on fleebay which came with EDIABAS, DIS, SSS Progman

I have spent nearly two days navigating through all the options. I have managed to get diagnostic information from the car, but I haven't found any way to activate the Aux Heater option (my car has the navigation option with monitor).

By reading around on the internet I got the idea that these are the exact tools necessary for the job, but I could not find any clear instruction, nor, as I said below any option in the software.

Beside navigating through the options with DIS and Progman is a painfully slow experience ...

I hope that someone here might be able to help.

Horizon · Post by **Horizon** » Sat Oct 20, 2012 11:37 am

Hi there I have the BMW 1.4.0.scanner, I activated mine with that, but it doesnt fire up properly, I havnt gone any further into it yet as it lives inside in the winter, I think you need a BMW specific Scanner to activate the AUX heating, where in the country are you ? a member near you with a scanner maybe able to sort you out for you

Steamyrotter · Post by **Steamyrotter** » Sat Oct 20, 2012 1:11 pm

Apparently you have to ..

"install" the module in DIS through the Body Control Module
Then update the build order.

Or

Go through NCS Expert and set it in the KMBI

these should bring the Aux Heat option on the OBC and allow timer function.

Remote will need either Telestart or A-N-other remote switching module covered many times on here.

dudelange · Post by **dudelange** » Sat Oct 20, 2012 1:41 pm

Steamyrotter wrote: Apparently you have to ..

"install" the module in DIS through the Body Control Module
Then update the build order.

Thank you. Which Module?

Or

Go through NCS Expert and set it in the KMBI

these should bring the Aux Heat option on the OBC and allow timer function.

Remote will need either Telestart or A-N-other remote switching module covered many times on here.

I am not sure if I have NCS Expert, actually I have read that it should be part of EDIABAS, but in any case I have read that it is dangerous to use. Any step by step guide?

wilkoturbo · Post by **wilkoturbo** » Mon Oct 22, 2012 7:33 am

[quote="wilkoturbo"]
Here how to activate with DIS v57

All done !!!
[/quote]

feksake · Post by **feksake** » Wed Feb 17, 2016 4:05 pm

Hi,
Cant open the pictures! Grrrrr just what i needed but canttttt grrrrrr
If anyone could re post the pictures or sumfink.
Rgds

X5Sport · Post by **X5Sport** » Wed Feb 17, 2016 5:10 pm

I think the poster removed them from his external reference folder. Piccies are not held on this site. I haven't seen traffic from this user for a while. You could try sending him a PM.

chrisswain · Post by **chrisswain** » Sun Dec 31, 2017 1:08 pm

Hi Please can i get the pictures on how to activate the heater either through dis or progman

Many thanks

kanewesley · Post by **kanewesley** » Sun Dec 31, 2017 5:56 pm

........and when you get them....send 'em to me please Bud !!!

XSeries-forum

XSeries-forum