Re: Tyre pressure sensors?
Posted: Sat May 05, 2012 11:49 am
[quote=""rusty nail""]It would make sense that the system would take the value from each sensor (each sensor will read differently as I'm sure they re not THAT accurate) when it is reset, and then monitors this value and if it moves out of a preset tolerance, the 'bing' occurs.
Simple software really
Sent from my iPad using Tapatalk[/quote]
This would appear to be the way it works, set the pressures as per the book, 2.2bar, reset the RDC control, then deflated the front right by approx .3 bar and the alarm activated, I then reset the RDC again and all was well. Altered the pressure back to the book setting and reset the RDC again.
The alarm must just look for deflation, ( obvious really ), as it didn't "bing" when I inflated the tyre again, before re-teaching.
Good job the neighbours weren't about, they think I'm a bit anal about cars anyway, god knows what they would have thought about me letting my tyres down, and then pumping them up again.
Simple software really
Sent from my iPad using Tapatalk[/quote]
This would appear to be the way it works, set the pressures as per the book, 2.2bar, reset the RDC control, then deflated the front right by approx .3 bar and the alarm activated, I then reset the RDC again and all was well. Altered the pressure back to the book setting and reset the RDC again.
The alarm must just look for deflation, ( obvious really ), as it didn't "bing" when I inflated the tyre again, before re-teaching.
Good job the neighbours weren't about, they think I'm a bit anal about cars anyway, god knows what they would have thought about me letting my tyres down, and then pumping them up again.
