XSeries-forum

Hello all,

Just bought a set of 4 genuine replacement BMW centre caps to go in my alloys as the others had gone weird and bubbly.
Dealer says pop them out from the back - but that means taking the wheels off!

Has anyone managed to pry them out without damaging their alloys?

I was thinking of carefully drilling a small hole and hooking them out! Bad idea?

Any tips appreciated.

UF

Yes, either drill a hole in middle and stick your screwdriver in, or use a bradle or similar to get them out. I don't remember them being difficult to get out.
Just out of interest, what did the new ones set you back if you don't mind me asking?


Sent from my iPod device using Tapatalk

I got a set from Alloywheels Direct. They were/are £37 a set.

Just pop them out with a screwdriver or similar. The oe ones aren't too bad to get out. I didn't take the rims off to get them off to replace.

hi
another option would be to use a house type downlighter halogen bulb changing tool , just a sucker that grips , push it on and pull and pop them out. just a thought !!

Cheers for the replies.
I got them from Sytner BMW Sheffield - they have an eBay page:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... _928wt_907
They cost £36.95 for 4.