As many of you are aware I have had a problem with my Bluetooth system in my X. When I tried to pair up my phone as per instructions nothing happened! When the pairing button was pressed under the Centre arm rest nothing happened.
I tried everything, even disconnected the BT module in the boot and tried all the different pairing sequences. I was told to check the connection under the phone cradle in the arm rest as the connectors sometime work themselves loose.
I took the cradle apart and low and behold the white connector had come from its location. If you have the same problem then here are some pics of the connector and its location.
Pull the cradle out of the arm rest by placing 2 credit cards either side of the cradle situated more at the back and pull the cradle up, it will have a cable attached ti it so be carefull. There will be 4 torx screws underneath the cradle, undo these and watch out for 2 springs, its ok if they come off,its obvious where they go back. Seperate the front and the back and you will see the cable in there which is supposed to be connected to a green circuit board, this had disconnected.
After seperating the front and back :
White connector attaches to the green circuit board:
Connector attached:
The connector comes out quite easily so I stuck the wires down with srtong tape to stop it coming out(not in pic). Replace everything and test by trying to pair your phone!
Hope this will be of some use to someone in the future!
Roy.
