Discussed this briefly before, I think it was Henry that did it but I can’t find the info again, I’m trying to finish my dynavin install and was going to move the NAV unit to the boot at the same time, anyone who’s done it - have you:
1. Managed to move the existing wires out of the loom and pull them back through to the boot
Or
2. Chopped the plugs off and extend the wires yourself with new cable into the boot
I thought someone said they used the existing cable but I can’t see how to get at it
Not joined yet? Register for free and enjoy features such as alerts, private messaging and viewing latest posts and topics.
Moving the NAV unit to the boot
-
sleepyfolk
- Member
- Posts: 452
- Joined: Fri Jun 06, 2014 12:07 am
Moving the NAV unit to the boot
Last edited by sleepyfolk on Sat May 05, 2018 1:28 pm, edited 1 time in total.
E53 X5 4.6is Carbon Black 2003
Mercedes CLK 320
Audi A6 Quattro 2.4
Mercedes CLK 320
Audi A6 Quattro 2.4