Moving the NAV unit to the boot
Posted: Sat May 05, 2018 11:57 am
Discussed this briefly before, I think it was Henry that did it but I can’t find the info again, I’m trying to finish my dynavin install and was going to move the NAV unit to the boot at the same time, anyone who’s done it - have you:
1. Managed to move the existing wires out of the loom and pull them back through to the boot
Or
2. Chopped the plugs off and extend the wires yourself with new cable into the boot
I thought someone said they used the existing cable but I can’t see how to get at it
1. Managed to move the existing wires out of the loom and pull them back through to the boot
Or
2. Chopped the plugs off and extend the wires yourself with new cable into the boot
I thought someone said they used the existing cable but I can’t see how to get at it