that would be handy! where abouts do you meet sanj?
stewie, how hard was it to do? do you havea link to the post you followed, might give it a bash myself.
cheers[/quote]
The install procedure is described in many locations on here, and is as follows :
1) Open tailgate and driver's door and leave open
2) Go to the boot and wait for the red light on your nav unit to go out, which may take a couple of minutes, be patient!
3) Eject the map disc, I've found that you need to press the eject button twice to do this, once to wake the unit up and once to eject the disc
4) Go back to the front and switch the ignition to position 1 - DO NOT close the driver's door!
5) Return to the boot and insert your newly-burned software disc
6) Look forward and observe the screen, it may go black for a few seconds and should then show "Software will update"
7) The update process will start and a progress bar will appear at the bottom of the screen, this phase may take up to 6 minutes
When the "Reboot" screen eventually appears, eject the software disc, go to the front and confirm reboot by pressing the right hand button9) Return to the boot and insert the map disc.
Don't rush the process, if your screen goes black and doesn't start the update process (Step 6) after 10 minutes or so then you have a problem, however, if you're methodical with the entire process, right from the file download point, then all should be absolutely fine.
